Commit d1f42226 authored by Robin Gong's avatar Robin Gong Committed by Jason Liu

ENGR00234685-2 mx6q_sabreauto: change Sabreauto board to LDO-ENABLED mode

Per hardware design, we can't set LDO bypass mode on Sabreauto board,otherwise,
system will can't reset,if cpu freq run in 400Mhz.
Signed-off-by: default avatarRobin Gong <>
parent 71a98a9d
......@@ -403,7 +403,7 @@ static int pfuze100_init(struct mc_pfuze *pfuze)
/*use default mode(ldo bypass) if no param from cmdline*/
if (enable_ldo_mode == LDO_MODE_DEFAULT)
enable_ldo_mode = LDO_MODE_BYPASSED;
enable_ldo_mode = LDO_MODE_ENABLED;
/*read Device ID*/
ret = pfuze_reg_read(pfuze, PFUZE100_DEVICEID, &value);
Markdown is supported
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment