Commit c4940e8b authored by Lauren Post's avatar Lauren Post Committed by Otavio Salvador

imx6qsabresd.conf: Add ldo and hdcp DTS

ENGR00274059-02 ARM: Add new dts for imx6q/imx6dl SabreSD hdcp

hdcp ddc pins conflict with i2c2,
add new dts file for imx6q and imx6dl SabreSD board,
enable hdcp and disable i2c2 in these dts files.
Remove hdmi pins property from mx6qdl-sabresd.dtsi.

ENGR00279402-1 ARM: dts: imx6: add wdog reset source seclect in dts

Some boards use another WDOG reset source to reboot system in ldo-bypass mode.
We need add the property in board dts file so that we can easily know the
WDOG reset source currently.

For Sabresd, WDOG1 for ldo-enable mode(WDOG event), WDOG2 for ldo-bypass mode
(reset external pmic to trigger POR event).
For sl-evk board, there is no WDOG pin connected with external pmic as Sabresd
, because mx6sl boot at 400Mhz. Then both ldo-enable and ldo-bypass mode use
the common WDOG1 as reset source.

ENGR00277895: dts: ARM: imx6: add ldo-enable dts files

  Currently, we use different dts files to support ldo-bypass or ldo-enable, then
we need add both dts files for the boards which can support ldo-bypass mode(all
boards support ldo-enable at least). So for below boards we need add ldo-enable
dts file so that we can use this to easily support ldo-enable mode:
  1)mx6q-sabresd board:  ldo-bypass dts->mx6q-sabresd.dtb,
                         ldo-enable dts->mx6q-sabresd-ldo.dtb
  2)mx6q-sabresd board:  ldo-bypass dts->mx6dl-sabresd.dtb,
                 ldo-enable dts->mx6dl-sabresd-ldo.dtb
  3)mx6sl-evk board:     ldo-bypass dts->mx6sl-evk.dtb,
                 ldo-enable dts->mx6sl-evk-ldo.dtb

Change-Id: I38fb55249a002888c9da2c5e298acca089759876
Signed-off-by: default avatarLauren Post <>
parent 61130550
......@@ -7,7 +7,7 @@ require conf/machine/include/
SOC_FAMILY = "mx6:mx6q"
KERNEL_DEVICETREE = "imx6q-sabresd.dtb"
KERNEL_DEVICETREE = "imx6q-sabresd.dtb imx6q-sabresd-ldo.dtb imx6q-sabresd-hdcp.dtb"
UBOOT_CONFIG[sd] = "mx6qsabresd_config,sdcard"
Markdown is supported
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment